Planet-technology WGS3-2840 Manual do Utilizador

User's Manual WGS3-2840 24-Port 10/100Mbps + 4G TP / SFP Combo Layer 3 Managed Switch - 1 -

- 10 - 2.2 Rear Panel The rear panel of the Layer 3 Managed Switch indicates an AC inlet power socket, which accepts input power from 100 to 240VA

- 11 - 2.3.2 Rack Mounting To install the Layer 3 Managed Switch in a 19-inch standard rack, follow the instructions described below. Step 1: Pla

- 12 - 3. SWITCH MANAGEMENT This chapter describes how to manage the Layer 3 Managed Switch. Topics include: - Overview - Management methods -

- 13 - access-list Config acl. arp Set a static ARP entry. clear clear something. commit Commit all the ACL and QoS Config to be valid. debug D

- 14 - 3.2 Management Methods There are four ways to manage the Layer 3 Managed Switch: - Local Console Management via the serial port of Layer 3

- 15 - 3.3 Assigning an IP Address to the Layer 3 Managed Switch To manage the Layer 3 Managed Switch remotely through the console port or with an

- 16 - 3.4 Logging on to the Layer 3 Managed Switch When you log on to the Layer 3 Managed Switch console port for the first time, the following m

- 17 - 4. WEB MANAGEMENT Before login the Web interface of Layer 3 Managed Switch, please setup the “IP Address” with local serial console port (R

- 18 - 4.2 System This section provides system information from Layer 3 Managed Switch, the screen in Figure 4-3 appears. Figure 4-3 System

- 19 - 4.2.1 IP Address This section allows modify the IP address, Subnet Mask, Gateway and VID (VLAN ID) of Layer 3 Managed Switch; also allow as

- 2 - Trademarks Copyright © PLANET Technology Corp. 2007. Contents subject to revision without prior notice. PLANET is a registered trademark of

- 20 - 4.2.2 System Information This section provides system information of Layer 3 Managed Switch, such as Model name, current IP Address, curren

- 21 - Use this Web page to disable or enable the SNMP function of Layer 3 Managed Switch, and define the management sta-tions as trap managers an

- 22 - Management Station A Trap manager is a management station that receives traps, the system alerts generated by the Layer 3 Managed Switch.

- 23 - 4.2.5 Console This section provides read-only Console information of Layer 3 Managed Switch. The screen in Figure 4-12 appears.

- 24 - Firmware Upgrade procedure: 1. Login to the Web management interface of Layer 3 Managed Switch. 2. Click on the "System" menu lin

- 25 - Figure 4-15 System Update Web Page screen 8. Please wait until the Layer 3

- 26 - 4.2.7 Save Parameters This section allows save current setting of Layer 3 Managed Switch. The screen in Figure 4-17 appears.

- 27 - 4.2.9 Backup & Recovery This section allows backup and recovery the system parameters of Layer 3 Managed Switch. The screen in Figure 4

- 28 - Figure 4-21 Backup the System parameters Web Page screen Parameters

- 29 - Figure 4-23 Parameters Recovery Web Page screen 3. Clink “OK” button to start

- 3 - TABLE OF CONTENTS 1. INTRODUCTION...

- 30 - When complete the Parameters Recovery process of Layer 3 Managed Switch, the following screen appears.

- 31 - 4.3 Port Management This section provides port configuration, port statistics and Band Restricting functions from Layer 3 Managed Switch. T

- 32 - 4.3.1 Port Configuration This section provides port configuration function from Layer 3 Managed Switch. The port configuration screen in Fi

- 33 - 4.3.2 Port Statistics This section provides port statistics function from Layer 3 Managed Switch. The port statistics screen in Figure 4-29

- 34 - 4.3.3 Band Restricting This section provides band restricting function from Layer 3 Managed Switch. The band restricting screen in Figure 4

- 35 - 4.4 Redundancy This section provides Rapid Spanning Tree and Link Aggregation function from Layer 3 Managed Switch. The Redundancy screen i

- 36 - 4.4.1 Rapid Spanning Tree This section provides Rapid Spanning Tree function from Layer 3 Managed Switch. The Spanning Tree Protocol (STP)

- 37 - RSTP Port Configuration This function provides Rapid Spanning Tree Bridge Configuration and view the Spanning tree Root Bridge information.

- 38 - 4.4.2 Link Aggregation This section provides Link Aggregation function from Layer 3 Managed Switch. The Link Aggregation screen in Figure 4

- 39 - 4.5 Route Service This section provides Static Route, RIP and OSPF function of Layer 3 Managed Switch. The Route Service screen in Figure 4

- 4 - 4.8.2 Static Routing Port...

- 40 - 4.5.1 Static Route This section provides Static Route function from Layer 3 Managed Switch. Static route provide manually intensive to keep

- 41 - 4.5.2 RIP This section provides RIP function from Layer 3 Managed Switch. The Routing Information Protocol (RIP), it is one of the most end

- 42 - 4.5.3 OSPF This section provides OSPF function from Layer 3 Managed Switch. OSPF (Open Shortest Path First) is a router protocol used withi

- 43 - 4.6 Security This section provides ACL, VLAN, ARP, Static MAC Address, MAC Address Filter, MAC Address Learning and MAC Aging time function

- 44 - 4.6.1 ACL This section provides ACL function from Layer 3 Managed Switch; this function provides ACL Configuration and view the ACL table i

- 45 - Extended IP ACL This section provides Extended IP ACL function from Layer 3 Managed Switch; this function provides Extended IP ACL Configur

- 46 - Protocol type-code This section provides Protocol type-code function from Layer 3 Managed Switch; this function provides Protocol type-code

- 47 - Standard MAC ACL This section provides Standard MAC ACL function from Layer 3 Managed Switch; this function provides Standard MAC ACL Confi

- 48 - Extended MAC ACL This section provides Extended MAC ACL function from Layer 3 Managed Switch; this function provides Extended MAC ACL Confi

- 49 - 4.6.2 VLAN This section provides VLAN function from Layer 3 Managed Switch; this function provides VLAN Configuration and view the VLAN mem

- 5 - 1. INTRODUCTION 1.1 Package Contents Thank you for purchasing PLANET Layer 3 Managed Ethernet Switch, the Layer 3 Managed Ethernet Switch p

- 50 - Please click one specific port for further IEEE 802.1Q VLAN configuration and then the following screen appears. Table 4-17 descriptions th

- 51 - Please click View VLAN Members button from the 802.1Q VLAN Configuration Web Page screen (Figure 4-45) then the following screen appears.

- 52 - 4.6.3 ARP This section provides ARP function from Layer 3 Managed Switch; this function provides ARP Configuration and view the ARP Table.

- 53 - Figure 4-50 ARP Configuration by VLAN Web Page screen

- 54 - 4.6.4 Static MAC Address This section provides Static MAC Address function from Layer 3 Managed Switch; this function provides Static MAC A

- 55 - 4.6.5 MAC Address Filter This section provides MAC Address Filter function from Layer 3 Managed Switch; this function provides MAC Address

- 56 - 4.6.6 MAC Address Learning This section provides MAC Address Learning function from Layer 3 Managed Switch; this function provides MAC Addr

- 57 - 4.6.7 MAC Aging Time This section provides MAC Aging Time function from Layer 3 Managed Switch; this function provides MAC Aging Time setti

- 58 - 4.7 QoS This section provides Port QoS Setting, CoS-DSCP Mapping, IPPRE-DSCP Mapping and Queue Scheduling function of Layer 3 Managed Switc

- 59 - 4.7.1 Port QoS Setting This section provides Port QoS Setting function from Layer 3 Managed Switch; this function provides Port QoS Configu

- 6 - 1.3 About the Layer 3 Managed Ethernet Switch The PLANET WGS3-2840 equip with 24-Port 10/100Mbps with 4 Gigabit TP/SFP Combo interfaces pl

- 60 - 4.7.2 CoS-DSCP Mapping This section provides CoS-DSCP Mapping function from Layer 3 Managed Switch; this function provides CoS-DSCP Mapping

- 61 - 4.7.3 IPPRE-DSCP Mapping This section provides IPPRE-DSCP Mapping function from Layer 3 Managed Switch; this function provides IPPRE -DSCP

- 62 - 4.7.4 Queue Scheduling This section provides Queue Scheduling function from Layer 3 Managed Switch; this function provides Queue Scheduling

- 63 - 4.8 Multicast This section provides IGMP Snooping, Static Routing Port, IGMP Port Policy and IGMP Group Policy Configuration of Layer 3 Man

- 64 - 4.8.1 IGMP Snooping This section provides IGMP Snooping function from Layer 3 Managed Switch; this function provides IGMP Snooping Configur

- 65 - 4.8.2 Static Routing Port This section provides Static Routing Port function from Layer 3 Managed Switch; this function provides Static Rou

- 66 - 4.8.3 IGMP Port Policy This section provides IGMP Port Policy function from Layer 3 Managed Switch; this function provides IGMP Port Policy

- 67 - 4.8.4 IGMP Group Policy This section provides IGMP Group Policy function from Layer 3 Managed Switch; this function provides IGMP Group Pol

- 68 - 4.9 Network Analysis This section provides Port Analysis, QoS Counter and Port Mirror function of Layer 3 Managed Switch. The Network Analy

- 69 - 4.9.1 Port Analysis This section provides Port Analysis function from Layer 3 Managed Switch; this function provides Port Analysis Configu-

- 7 -  Supports IGMP Snooping Security  User/Password protected system management  L3/L4 ACL (Access Control List)  Static MAC address

- 70 - 4.9.2 QoS Counter This section provides QoS Counter function from Layer 3 Managed Switch; this function provides view the QoS Counter Table

- 71 - 4.9.3 Port Mirror This section provides Port Mirror function from Layer 3 Managed Switch; this function provides Port Mirror Configuration

- 72 - 4.10 DHCP Relay This section provides DHCP Relay function of Layer 3 Managed Switch. The DHCP Relay screen in Figure 4-70 appears and Table

- 73 - 4.11 Storm Control This section provides Storm Control function of Layer 3 Managed Switch. The Storm Control screen in Figure 4-71 appears

- 74 - 5. TROUBLESHOOTING This chapter contains information to help you solve issues. If the Layer 3 Managed Switch is not functioning properly,

- 75 - APPENDIX A NETWORKING CONNECTION A.1 Switch‘s RJ-45 Pin Assignments 1000Mbps, 1000Base T Contact MDI MDI-X 1 BI_DA+ BI_DB+ 2 BI_DA- B

- 76 - Figure A-1: Straight-Through and Crossover Cable Please make sure your connected cables are with same pin assignment and color as above pi

- 8 - 1.5 Specification Product WGS3-2840 Hardware Specification 10/100Base-TX Ports 24 RJ-45 Auto-MDI/MDI-X ports 10/100/1000Base-T Ports4

- 9 - 2. HARDWARE INSTALLATION This product provides three different running speeds – 10Mbps, 100Mbps and 1000Mbps in the same Layer 3 Managed Sw