Planet Technology VC-412 Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Redes Planet Technology VC-412. Planet Technology VC-412 User's Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir

Resumo do Conteúdo

Página 1 - User’s Manual

Intelligent Ethernet over VDSL Switch VC-412 User’s Manual

Página 2

VC-412 User’s Manual 6 2. INSTALLATION 2.1 Connecting VC-412 The VC-412 has the ability to provide u

Página 3

VC-412 User’s Manual 7 2.2 Console Port Setup

Página 4

VC-412 User’s Manual 8 The VC-412 contains a powerful management interface accessible through the Co

Página 5 - 1. INTRODUCTION

VC-412 User’s Manual 9 . Once you have assigned a valid IP address to the Switch, proceed to chapter

Página 6

VC-412 User’s Manual 103. WEB CONFIGURATION 3.1 Web configuration setup Configuration through Web br

Página 7

VC-412 User’s Manual 11 E. A password dialog will appear prompting for username and password. The

Página 8

VC-412 User’s Manual 123.2 Monitor Configuration 3.2.1 Unit Information After the correct username a

Página 9

VC-412 User’s Manual 13 3.2.2.2 TRUNK PORT INFORMATION Under this section you will be able to mon

Página 10 - 2. INSTALLATION

VC-412 User’s Manual 14settings of the switch such as refresh time (the rate at which the monitoring

Página 11 - 2.2 Console Port Setup

VC-412 User’s Manual 153.3.3 Reboot System Reboot System option reboots the VC-412 when it seems to

Página 12

VC-412 User’s Manual 1 Trademarks Copyright  PLANET Technology Corp. 2002. Contents subject to r

Página 13 - 2.3 Telnet Setup

VC-412 User’s Manual 16 3.4.2 SNMP Access Table Under SNMP Access Table and SNMP Trap Receiver Tabl

Página 14 - 3. WEB CONFIGURATION

VC-412 User’s Manual 17 3.4.3 SNMP Trap Receiver Table The SNMP Trap Receiver Table is a set of us

Página 15 - VC-412 User’s Manual

VC-412 User’s Manual 18Note: Be sure to press the Set Value button at the bottom of the screen to ad

Página 16 - 3.2 Monitor Configuration

VC-412 User’s Manual 194. COMMANDS FOR CONSOLE AND TELNET Once successfully logged into the VC-412,

Página 17 - 3.3 System configuration

VC-412 User’s Manual 20 4.2.1 System Configuration Choosing System Configuration will allow you to

Página 18 - 3.3.2 Reset To Default

VC-412 User’s Manual 21 Figure 24 II. To change password select option 7 and press “Enter” key. T

Página 19 - 3.4 Network Configuration

VC-412 User’s Manual 22 Important: There is only one set of password; therefore the password will

Página 20 - 3.4.2 SNMP Access Table

VC-412 User’s Manual 23the VC-412. Note: The password for HTTP is the same as the password in Consol

Página 21

VC-412 User’s Manual 24Enter key, otherwise press Enter key without entering any information to canc

Página 22

VC-412 User’s Manual 25 4.3 SNMP Access Table/SNMP Trap Receive Control Table Choosing option 2 in

Página 23 - 4.2 Management Configuration

VC-412 User’s Manual 2 1. INTRODUCTION...

Página 24 - 4.2.1 System Configuration

VC-412 User’s Manual 264.4 VDSL Unit Control To monitor and issue commands to the VC-412: Select opt

Página 25 - Figure 24

VC-412 User’s Manual 27 4.4.3 Display All Ports Status of Unit This option displays the statuses of

Página 26 - 4.2.2 Network Configuration

VC-412 User’s Manual 28The E/S/A/Er Column represents the current operating status of the ports. E-

Página 27

VC-412 User’s Manual 29 Note: Packet throughput is polled every 6 seconds. 4.5 Reset To Default At t

Página 28

VC-412 User’s Manual 30 4.7 Logout After finished issuing commands to the VC-412, it is recommended

Página 29

VC-412 User’s Manual 315. ICD COMMANDS FOR TELNET AND CONSOLE NOTE: DO NOT ATTEMPT TO ISSUE COMMAND

Página 30 - 4.4 VDSL Unit Control

VC-412 User’s Manual 32 The above line indicates “U00-ICD>”. The unit is now ready to be adminis

Página 31

VC-412 User’s Manual 33VDSL port Enable Speed Mode = Auto Speed X To exit ICD command prompt VLAN C

Página 32

VC-412 User’s Manual 34P Show the status of all ports. Legend: RS Err = Reed Solomon Error AUT =

Página 33 - 4.6 Reboot System

VC-412 User’s Manual 35non-communicative to the other ports on the VC-412 in regards to local traffi

Página 34 - 4.7 Logout

VC-412 User’s Manual 3 4.4.2 Set Each VDSL Port Name of Unit ...

Página 35

VC-412 User’s Manual 36VG 1-1,2,A Add port-4, port-8 and port-D to group 1 from previous example VG

Página 36 - 5.2 ICD command Index Table

VC-412 User’s Manual 37connected port of the VC-412 to the same speed. The reason you need to set th

Página 37 - Speed Mode = Auto Speed

VC-412 User’s Manual 38 The “PC” command displays all ports Transmit, Receive and Collision statuse

Página 38

VC-412 User’s Manual 39APPENDIX A – VC-412 FACTORY DEFAULT Virtual LAN – On Ethernet Speed – 100 F

Página 39 - Examples:

VC-412 User’s Manual 40 APPENDIX B – UPDATE VC-101S FIRMWARE TO R4.5 REMOTELY THROUGH VC-412 The pur

Página 40 - 5.4 VDSL Command

VC-412 User’s Manual 41can not be saved. Thus, you have to continue the following command to upda

Página 41 - 5.5 Port Command

VC-412 User’s Manual 42 For more detailed ICD command description please refer to the Chapter 5.

Página 42

VC-412 User’s Manual 1 1. INTRODUCTION Thank you for choosing the VC-412 VDSL Managerial Switch fo

Página 43 - IP Address – 192.168.1.1

VC-412 User’s Manual 2  Back Pressure and IEEE 802.3x compliant flow control  Supports 8K MAC ad

Página 44 - R4.5 REMOTELY THROUGH VC-412

VC-412 User’s Manual 3  Operating Temperature: 32 to 122°F (0 to 50°C)  Storage Temperature: -13

Página 45

VC-412 User’s Manual 4 1.4 LED Indicators And Button Definition LED Function Color Status Descri

Página 46

VC-412 User’s Manual 5 Button Function Reset Push to reboot the switch Normal / Uplink Normal: Whe

Comentários a estes Manuais

Sem comentários